If you rely on your car, you need to make sure it's as healthy as possible. Installed two months ago and no problems. However after you have installed the new thermostat and put the rad top hose back on, all the guides say to simply top up any coolant lost through taking the rad hose off in the first place. Refilling is a little trickier. Toyota Parts Deal is your prime online source with the biggest and best selection of genuine Toyota parts and accessories at giant discounted prices. Also, you don't need to worry about price here, and the amount here is cheap and affordable.
All done while standing on your feet. It's a genuine Toyota thermostat for my 2000 Corolla. Fairly simple unless you have corroded bolts that hold the alternator. I thought taking the rad top hose off would get too much air in the cooling system and it would have to be completly drained and filled? Works like a thermostat should. There is an automatic switch in the thermostat which changes between closed and open. Hope this helps, in lieu of a picture. The problem was that my old thermostat was stuck open.
Definitely worth the extra buck or two. I thought taking the rad top hose off would get too much air in the cooling system and it would have to be completly drained and filled? Otherwise it would really damage your engine if it fails shut. I used a breaker bar with the handle from the jack over the end to undo the alternator, couldn't use the breaker bar for the tensioner as there wasnt enough room to pull it forwards to reduce the tension enough. Good news is that with all the practice I got the first time, replacement was a breeze. My vibe has 200,000 miles and I just did mine as preventative maintenance since I was doing the rest of the coolant system and super flushing it.
Since the thermostat is firmly related to the engine, and the engine is the heart of your Toyota. It never overheated or got high in water temperature so I questioned that the code could be cooling system related. Carefully remove the cover and pull out the filter. A replacement thermostat for Toyota Corolla solves this issue, along with odd boiling and knocking noises caused by this component failing. Seems to be a genuine Toyota part, but who knows. It is the temperature sensor inside the thermostat which makes this function possible.
Order the gasket as well. Also got an leak to look for, its going to be a busy day! I followed the hose off the radiator, but it seems to disappear into the engine. When the thermostat is closed, there is enough coolant in the engine, and it is at or below the correct temperature. I followed the hose off the radiator, but it seems to disappear into the engine. I tried ensuring that I let it warm up for a good long time first, which usually helped, but often it would throw the Check Engine Light during driving. Got a thermostat from eurocarparts, hopefully will be just as good as the toyota ones as I do 100 motorway miles a day.
Is it really that simple? Drain the coolant, remove the 2 nuts that holds the housing on, and remove it. Cheers No you donot need to be under the car when changing it. Would have just gotten a 5 dollar one at O'Riley's if I knew I was going to have to go through all that hassle. Was packaged kind of ghetto and I was concerned that it might be damaged but it worked fine and had the genuine sticker. Open this bleeder screw, usually a 10mm, or 12mm socket will fit, and fill the cooling system with the recommended coolant.
Once cool, the psv seats and the fluid is drawn back the other way. A new Toyota Corolla thermostat from AutoZone ensures that your engine stays at the right temperature and doesn't overheat. However after you have installed the new thermostat and put the rad top hose back on, all the guides say to simply top up any coolant lost through taking the rad hose off in the first place. It will be hugely dangerous if you run your Toyota with a declining thermostat. You test in a pot of boiling water with a thermometer, it should be opening or basically fully open by about 85 degrees. Hi, Got myself a new thermostat, Where is it located on the car so I can change it? Trace the upper radiator hose to the mounting area on the intake manifold. I followed the hose off the radiator, but it seems to disappear into the engine.
Thanks for the detailed reply. Most Toyota's along this year model have the thermostat located in the engine, where the lower radiator hose connects to the engine. I would recommend always testing it when you get one. Once the temperature of the engine reaches a set higher temperature point, the thermostat opens up to let more coolant in to stop the engine from being overheating. You fill the coolant through the radiator cap! Which means the engine needed extra time to reach optimal operating temperature.
The only way I could do it is to blow on the overflow tube until there was coolant coming out of the rad cap the rad cap was off. Ok, basically I have read how to change you cars thermostat and it seems relatively simple to do. Got the thermostat changed - the seal on the back had half come off, stopping it closing properly. The only inconvenience is having to find the gasket that goes around this thermostat. Ok, basically I have read how to change you cars thermostat and it seems relatively simple to do. Sep 22, 2011 I have an 06 corrolla.
Location of radiator outlet hose clamp 1 at thermostat cover for the removal of the radiator outlet hose from the thermostat cover - 2. Im sure they are made so if they fail they fail open. The thermostat is a valve made of metal and has a built-in temperature sensor. Even though the part is no longer needed or damaged during the deliver process, you can request for returning the part without any hassle. It's a great investment as long as you pay attention to how it performs.