Your new, unprogrammed key is now programmed. The belt will still retract to remove any slack in the shoulder belt. For normal operation, move control up two positions. Engine oil filler cap 3. Stop the vehicle as soon as safely possible, switch off the engine and let the engine cool. Lift the control to adjust the angle of the seatback. This may consist of cornstarch, talcum powder to lubricate the bag or sodium compounds e.
In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. The headlights and front grille were completely redesigned, getting rid of the turn signals inside the grille. Failure to seek proper medical attention could lead to permanent injury. Make sure the tongue is securely fastened in the buckle. The decisions of the Board are binding on Ford and, in some cases, on the authorized dealer but not on consumers who are free to pursue other remedies available to them under state or federal law.
When a wheel is installed, always remove any corrosion, dirt or foreign materials present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Ford Motor Company will repair or. If fuel is splashed in the eyes, remove contact lenses if worn , flush with water for 15 minutes and seek medical attention. Accelerate to the desired speed. After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions. To reset the switch: 1.
For high speed operation, move control up three positions. Additionally, keeping records during summer and winter will show how temperature impacts fuel economy. In this guide, answers to such questions are contained in comments highlighted by the warning triangle symbol. The cold inflation pressure should never be set lower than the recommended pressure on the Safety Compliance Certification Label. Allow the safety belt to retract to remove any slack in the belt. Set the fan speed to the highest setting.
There are various features which have distinguished our pdf guidebook from other online available manuals. Parking brake To set the parking brake 1 , pull the parking brake handle up as far as possible. Release the button and pull down on the height adjuster to make sure it is locked in place. Rate 7 compensates the most volume at higher speeds. This will automatically return the vehicle to the previously set speed.
Although the indicator light is illuminated, the heat is regulated by a thermostat which causes the heat to activate within a certain range. Connect the negative - cable to the negative - terminal of the assisting battery. Store an extra programmed key away from the vehicle in a safe place to help prevent any inconveniences. If the light remains on, have the system serviced immediately, refer to the Driving chapter for more information. Ford is also allowed a final repair attempt in some states. If it enters the red section, the engine is overheating.
Set the parking brake and shift to P Park. Never use pillows, books, or towels to boost a child. Insert the indicator fully, then remove it again. Have the system checked by your Ford Dealer immediately. Apply the brake and shift into the neutral position. If a metal-to-metal, continuous grinding or continuous squeal sound is present, the brake linings may be worn-out and should be inspected by an authorized dealer. If your vehicle is to be towed from the rear using wheel lift equipment, the front wheels drive wheels must be placed on a dolly to prevent damage to the transmission.
The fuel system may be under pressure. Remove the head restraint s if equipped of the rear seat, and fold the seatback forward. Always set the parking brake fully and make sure the gearshift is latched in P Park. See the following for a brief description on each control. See your authorized dealer for service of this fuse.
Copyright © 2005 Ford Motor Company. Stow the head restraint s in the plastic retainers provided in the now upright underside of the seat cushion, as shown on the decal. Move the control in the direction you wish to tilt the mirror. Use of these systems may result in vehicle starting problems and a loss of security protection. The lighter will be released from its heating position when it is ready to be used.